from Early 250 280SLArticle code: v.nr.1103200047

FOUR ARE REQUIRED PER CARArticle code: v.nr.1132620034

TACHOMETER CABLE ALL 113 MODELS RHD W/1950MM Length

ENGINE SIDE OF CABLE LOCATED UNDER CAP THAT ACCEPTS TACHOMETER CABLE IN ENGINE COMPARTMENT.Article code: v.nr.0119976447

Will include plug and seal for temp. sensor hole that is not used on early vehicles. plug 007604014110 ring 007603014100 cover seal ring 0159972348Article code: v.nr.1272030974

all ModelsArticle code: v.nr.0015459224

THREADED PLUG  Crankcase M42 X 1.5  Fits many Different Models 117 Shown in picture Be sure to check via MB 1179970230 

NOT AVAILABLE AT THIS TIME MOUNTED ON TOP OF INTAKE TO DAMPEN THROTTLE CLOSING UPON DECELERATION. PREVENTS STALL & CHOKE. EARLY CARS (230SLs) MAY REQUIRE ADDITIONAL MOUNTING BRACKET/S.

COMPLETE REPAIR KIT TO REMOUNT REAR OF THRUST ARMS TO REAR AXLE. 1 KIT DOES BOTH SIDES.Article code: v.nr.1103501475

Article code: v.nr.1103521065

Article code: v.nr.1103521065

Article code: v.nr.1103521065

  THRUST PIECE (THRUST,OIL PUMP) Fits All Mercedes-Benz SL W113 Models from 1963 to 1971

1960-71 3.5mm Thick 15mm Wide Valve Adjustment Shim  

3.5mm thickness. ROUND DISC WITH SLOTTED CENTER USED FOR VALVE ADJUSTMENT. FITS ALL 113s UP TO 280SL WITH ENG. # 10-005464 & 12-009136. 12 PER CAR.

3.5mm THICKNESS. ROUND SHIM WITH SLOTTED CENTER USED FOR VALVE ADJUSTMENT. FOR 280SLs FROM ENG. # 10-005465 & 12-009137. 12 PER CAR.

4.5mm THICKNESS. ROUND DISC WITH SLOTTED CENTER USED FOR VALVE ADJUSTMENT. FOR 280SL FROM ENG.# 10-005465 & 12-009137. 12 PER CAR.Article code: v.nr.1300530353

4.5mm THICKNESS. ROUND DISC WITH SLOTTED CENTER USED AS VALVE ADJUSTEMENT SHIM. 12 PER CAR FOR ALL 230SL, 250SL, & 280SL UP TO ENG. # 10-005464 & 12-009136.Article code: v.nr.1800531952

Article code: v.nr.1073300103

left hand Thread.Article code: v.nr.0003385010

PART NOT AVAILABLE AT THIS TIME. PART OF THR HOT START MODIFICATION. ALLOWS FOR A 1 SECOND FUEL DISCHARGE FROM THE COLD START VALVE IN WARM ENGINES TO IMPROVE HOT START. IF NOT PREVIOSLY INSTALLED, WILL ALSO NEED HARNESS # 54-2132.

WIRE HARNESS NEEDED TO INSTALL TIME LAG RELAY # 54-2131 IF NOT PREVIOUSLY INSTALLED.Article code: v.nr.1085401009

BUSHING MOUNTED BEHIND TIMING GEAR # 05-2011.Article code: v.nr.6150520150

ALL METAL FILTER APPROXIMATELY 5.50 IN DIAMETER. WILL COME WITH PAN GASKET AND PLUG SEALS. FITS ALL 230SLs AND 250SLs WITH TRANS. # UP TO 006749 AND THEN WITH TRANS. # FROM 009936 UP TO 023010. AFTER THIS, USE KIT # 27-2010. W108/109/110/111/113